Change over from one source of power supply to another including any interruptions in electrical supply should not require the equipment to be manually reinitialised for a period of 45 seconds.
Ecdis power supply requirements.
Requirements set out in resolution msc 191 79 ecdis equipment should meet the requirements of these standards and follow the relevant guidelines on ergonomic.
Confirm that the ecdis has adequate power supply arrangements in place as defined by imo and flag state requirements.
A second compliant ecdis which must be independent of the main ecdis and connected to the ships main and emergency power supply refer solas regulation chapter ii i.
Are acceptable as the requirements vary.
And vii connection cable for interface between main ecdis and back up ecdis shall be.
Ecdis regulations solas regulations.
The ecdis should be able to operate in a normal capacity even when it is connected and supplied by an emergency source of electrical power.
Ups systems plc has a longstanding reputation for supplying marine approved ups units and can provide the widest range of options to back up critical onboard instruments and enable you to meet with imo rules.
Following the introduction of performance standards for electronic charts in 1995 the maritime safety committee msc the highest technical body of the international maritime organization imo adopted an amended chapter v safety of navigation of the international convention for the safety of life at sea solas.
5 4 when an ecdis is switched on following a switch off or power failure it should return.
An uninterruptible power supply ups provides backup in the event of power failure to ensure the ecdis can keep running smoothly.
For australian flagged ships you have two options to meet the back up requirements for ecdis.
An ecdis system using encs with an independent power supply an appropriate folio of corrected up to date paper charts for the present voyage a raster chart display system rcds also known as an electronic chart system ecs using raster navigational charts rncs with an independent power supply.
Ultimately the purpose of the guideline is to ensure that an in.
Vi connection cables to gyro compass speed log and gps receiver shall be separated from.
This method of enc supply is known as.
Information system ecdis installation to determine if the ecdis meets the operational requirements defined by the international maritime organization imo.
It must also be connected to systems providing continuous position fixing.
Connection cables for the main ecdis.
Power supply of the main ecdis.
